The car is well protected from touching the top beam. The lifting is stopped automatically if a car roof touches a soft safety bar.
Asymmetric columns design allows to open car doors widely. Additional rubber pads on columns reliably protect car doors at an accidental contact

Secure hydro station placement at about 2 meters height. Saves working space and completely eliminates the risk of the hydro station or a supply tank accidental damage
Lifting platform control is carried out by ergonomic control board buttons
Safety mechanical latches are installed in each column. Removal from plungers is carried out by a convenient control board lever.

Columns and synchronization cross beam of the lift platform are designed without any detachable connections to increase a car rigidness and stability
Enlarged lift platform pile reliably holds a column without putting any additional stress on a foundation and anchors
Reinforced H-shaped carriage of the increased height distributes the load evenly inside the column, provides the support system rigidness and eliminates skewing

Car holding is provided by every 10 cm locking on both columns. First plunger is placed at a height of 315 mm.
Electric lock with a key to block an unauthorized access to the control board
Parachute valves provide smooth lowering on the plunger in a hydraulic system depressurization accident  
Reliable function of support position automatic locking during the carriage lifting.  Wide gear segments provide the supports immovability under high load.

Allow to service low-clearance cars
Supports slackness compensation system provides reliable maximum load holding in a fully extended position
The lift platform is equipped with two stands set of 70 and 100 mm. You can use it in any combination providing the lift support height from 95 to 295 mm
Galvanized screw piles allow to regulate supports accurately for any car

Designed for passenger cars and cross-country cars of total weight up to 4,2 tons
Maximum lift height 1845 - 2040 mm
Minimum lift support height – 95 mm
Stands of different height are included in a package set. You can use it in any combination providing the lift support height from 95 to 295 mm
Asymmetric columns provide better access inside the interior of a car installed on the lift platform
Frame cars lifting using additional adapters